Classic Alfa Forums

Although it's unfortunately relatively quiet here on the board recently I'll try my chances anyway.

I am looking for the clips with which the skirts are attached to the sill for an S2 Ti. These clips consist out a round receiving part (part number 109138) which is inserted into the sill and a pen like part (part number 109139) which is inserted into the receiving part. These clips are entirely different from the S3 Ti ones! Anybody here who dismantled a S2 Ti in the past and is willing to help out?

Since these S2 Ti unique clips are an absolute unobtanium I had them reproduced by 3D print. The prototype was tested yesterday and considered a good solution. It's a reproduction so therefore not 100% the same as the original, but the external appearance is similar/same and most importantly the functionality is given.

In case somebody is interested in obtaining these clips you can approach the gentleman "Stijn" who modelled and tested these 3D print clips (that's not me) by sending a Whatsapp to:

+31 (0)6-Four Zero Two 163 Three Four (telephone number purposely written this way to avoid spam robots picking it up, replace the written numbers by the digits).